ShelterLogic ShelterTube 62807 Manual De Instrucciones página 12

10. cover instAllAtion - continued
After pulling the cover over the frame, make sure to center cover on frame. There should be an equal
amount of overhang at all four corners.
E. Insert the "S"- Hook on ratchet (# 10040) into hole on the leg bend. Insert the webbing into the spindle of the
ratchet and pull tight. Wind the ratchet so that the webbing overlaps itself.
F. Slide Cover Rails (# 801345) through fabric pockets in cover and attach with clamps (# 801342 & # 801343)
at about 8 inches up from the ground to each leg. Repeat this on other side. Push down on cover rails to
tighten cover before tightening bolts (# 00648) completely.
NOTE: Place Cover Rails and Clamps UNDER the Anchoring Cables.
G. Check and tighten Ratchets and Cover Rails monthly to ensure the cover is tight.
NOTE: The ShelterLogic
be oriented as shown below.
e
logo should
®
CORRECT
801343
0690A
00690
10040
F
801343
00648
00828
Page 12
0690A
00690
05_62807_62810_A2
INCORRECT
801342
00648