Cleaning And Maintenance - SmartLife SL-WMTL60M Manual De Instrucciones

CLEANING AND MAINTENANCE

Before your maintenance starts, please unplug the machine and close the tap.
Cleaning the cabinet
Proper maintenance on the washing machine can extend its working life. The surface
can be cleaned with diluted non-abrasive neutral detergents when necessary. If there is
any water overflow, use the wet cloth to wipe it off immediately. No sharp items are
allowed.
Formic acid and its diluted solvents or equivalent are forbidden, such as alcohol,
solvents or chemical products,etc.
Cleaning the inlet filter
Inlet filter must be cleaned if there is less
water.
Washing the filter in washing machine:
1. Screw off the inlet pipe from the backside
of the machine.
2. Pull out the filter with long nose pliers
and reinstall it back after being washed.
3. Use the brush to clean the filter.
4. Reconnect the inlet pipe.
Lint filter clean
1. There is a built-in lint filter in your washer.
It can help to collect lint during washing
cycle.
2. It is suggested to clean the lint filter every
10 cycles.
3. Take it out and clean the filter with water.
Then place it back into the washer.
Magic filter
Normal filter
29
Cleaning drain pump filter
Be careful of the hot water!
Allow detergent solution to cool down.
Unplug the machine to avoid electrical shock before washing.
Drain pump filter can filter the yarns and small foreign matters from the washing.
Clean the filter periodically to ensure the normal operation of washing machine.
1
Drain the water out of the Open the filter by turning
pump, under which use a to the counter clockwise.
container to collect.
4
Clean the filter. Restore it and adjust the
convex place to align at the
pump hole.
Make sure that valve cap and emergency drain hose are reinstalled properly,
cap plates should be inserted aligning to hole plates otherwise water may leak;
Some machines don't have emergency drain hose, so step 2 and step 3 can be
skipped. Rotate lower cover cap directly to make water run into basin.
When the appliance is in use and depending on the programme selected there
can be hot water in the pump. Never remove the pump cover during a wash
cycle, always wait until the appliance has finished the cycle, and is empty.
When replacing the cover, ensure it is securely re-tightened.
2
Remove extraneous
matter.
5
Tighten the pump
cover clockwise.
30
3
6