Operation; Control Panel Operation; Menu Map; Configuration (Standalone) - Chauvet DJ SCORPION BAR RG Manual De Usuario

4. O
PERATION
This product is not designed for continual use. Make sure there are regular breaks during operation to maximize the life
of your laser. Always disconnect the Scorpion Bar RG from power when not in use.
Control Panel

Operation

Menu Map

Mode
DMX
Auto
Speed
Sound
IR Function
Configuration
(Standalone)
Sound-Active
Mode
Scorpion Bar RG User Manual Rev. 1.1
To access the control panel functions, use the four buttons located underneath the display.
When the product is on, the LED monitor on the rear panel will show the current operating mode
(Standalone or DMX). The product will retain the last saved settings when powered off.
Button Function
<MENU>
Selects an operation mode or backs out of the current menu option
<UP> Scrolls up the list of options or selects a higher value
<DOWN> Scrolls down the list of options or selects a lower value
<ENTER> Activates a menu option or a selected value
Programming Steps
2 H
10H
P--
S--
SND
SET
Set the product in one of the Standalone modes to control without a DMX controller.
Connect the product to a suitable power outlet.
Never connect a product that is operating in any Standalone mode (Static, Automatic, or
Sound) to a DMX string connected to a DMX controller. Products in Standalone mode may
transmit DMX signals that could interfere with the DMX signals from the controller.
To enable the Sound-Active mode, do the following:
1. Press <MENU> repeatedly until SND shows on the display.
2. Press <ENTER> and SN1 will show on the display.
3. Turn the music on and adjust the sound sensitivity knob until the product starts responding to
the beat of the music.
The product will only respond to low frequencies of music (bass and drums).
The product will blackout when in Sound-Active mode after 3 seconds of silence or noise
below the sensitivity setting.
Description
001–511
Sets DMX personality and address
001–503
P 1–P12 Selects Auto Program Effect
S01–S99 Speed for Sound Mode and Auto Programs
SN1
Selects Sound Active Mode Program Effects
on
On/Off IR functions
oFF
Page 19 of 110