Monster MST3304MBG Manual Del Propietário página 3

ASSEMBLY INSTRUCTIONS
Step 1: Assembly Preparation
NOTE
Cover workbench to prevent any damage to surface.
Remove all contents from box. Reference the parts list
to make sure you have all the parts. Place cart on its
back on a covered table.
CAUTION
Verify your workbench can support 150 lbs. (68 kg.).
Failure to follow this warning could result in damage to
property or personal injury.
Step 2: Pry Bar Holders
Lay two legs down on the table top and attach pry bar
holder as shown in figure 2. Repeat with other two legs
and pry bar holder.
NOTE
Ensure that both locking casters are on
same end of the cart as the side handle.
NOTE
Before moving to step 3 place a covering
on the floor (to protect the cart) and finish assembly
on the floor.
Step 3: Aligning the Legs
Make sure the drawer assembly lid is open. Attach the
bumper /prybar asssembly onto the cart box and bottom
tray. NOTE: Notched out area should be towards the
top of the cart. Repeat on opposite side of service cart.
Hand tighten so all holes will line up.
MST3304MBG
1.
2.
3.
3.
3 rev. 10/02/18