Operating - Medisana IPL 836 Instrucciones De Manejo

3.3 The device allow setting the light intensity levels 1 to 4. To start with you
Light should initially begin with Level 1 and check whether the application runs
intensities
without complications (see chapter 4 "Operating"). Then slowly you can
subsequently (depending on your hair and skin colour) switch to higher
levels, if necessary. Observe the last page of these operating instructions
for this. The table shows which light intensities are best suited in conjunc-
tion with your hair and skin colour or whether these methods are suitable
for you at all (if not, this is shown by an 'X" on the table).

4 Operating

4.1 The IPL 836/840 Hair Removal System is only suitable for skin types I to
Preparation
VII. Skin type VIII (darker skin type) as well as heavily browned skin are not
suitable for treatment with this device. Before starting the application, the
following points must be observed:
1.
2.
3.
4.
5.
3 Useful Information / 4 Operating
Observe all safety instructions and the possible side effects, which are
described in this guide.
Using the light intensity table (you will find it on the rear side of these
operating instructions) which intensity level is suitable for you (depend-
ing on skin and hair colour). An "X" means that the device is not suit-
able for you.
The areas of skin which should be treated with the device should be as
free of hair on the skin surface as possible. You can shave the areas or
shorten the hairs situated there. But do not use a hair removal cream.
The areas to be treated must be hairless, completely dry and free from
oily or creamy substances, powder, make-up or deodorant etc.
Before the very first use of the IPL 836/840 first a skin test is to be car-
ried out (see next chapter).
GB
41