Amplicomms TV 210-NL Manual De Instrucciones página 15

TV 210-NL
1 Connect the power adapter to the DC IN input socket located on the
transmitter rear panel and connect the power adapter to an electrical outlet.
2 Connect the transmitter with the audio source using the audio cable
provided. If necessary, use one of the audio cable adapters.
3 Slide the power-on switch on the rear side of the transmitter to the
position ON. The power indicator LED will light green.
Set up the receiver
The receiver comes with a built-in rechargeable battery.
Place the receiver into the charging cradle and make sure
the battery is fully charged before first use (charging LED
indicator lights red). This will take approx. 2 hours. If the
battery is fully charged, the charging LED indicator lights
green. A fully charged battery provides up to 9 hours of
listening enjoyment.
1 Take the fully charged receiver from the cradle and switch it on (ON). The
power indicator LED will light green.
2 Switch on the audio source.
3 The neck-loop induction cable can transmit the audio signal to the
hearing aid device for listening (Note : any earphone/headset must be
pulled out from the 3.5 mm audio output jack).
4 Adjust the tone clarity setting to achieve optimum performance.
Hearing damage due to high volumes!
• Before putting the receiver on lower the volume setting and gradually
increase the volume to suit.
• Do not continuously expose yourself to high volumes.
12