Tabla de contenido
160304 The reader is used to access areas by means of a
EN
transponder card.
The reading and the corresponding signaling or activation command,
occur in real time, thanks to the microprocessor on board the same
reader that stores data relating to the chip card at the same time
check-in. The LED on the front indicates the reading of a
card enabled.
The reader to gain access to the areas is installed externally on the side of
door handle, perfacilitare connection for electric mounted on the door jamb.
FEATURES
- RECOGNITION IN READING
TRANSPONDER CARDS
- VALIDATION AND QUALIFICATION
OPENING PORT
- LED CARD ACCEPTED
- FEATURES BOTH ONLINE AND IN LOCAL
- SELF-DIAGNOSIS DISPLAY DIRECT
SOFTWARE MALFUNCTION
- ADDRESSING SOFTWARE
- DIRECT REPROGRAMMING ALSO
BY SOFTWARE
Power supply voltage
Total absorption
Output flow (cos= 1) cat AC1
protection
Approvals
Operating temperature
Storage temperature
Relative air humidity
TECHNICAL CHARACTERISTICS
- MICROPROCESSOR WITH MEMORY
EEPROMFLASH THAT PREVENTS THE
BATTERIES BUFFER
- THE CONNECTORS FOR DATA
TRANSMISSION ARE PULL-OUT (RJ 11)
- MAINTAIN SETTINGS ALSO IN THE
CONTROLLER TURNED OFF
- RELAY 3A 230VAC-CONTROLLED DIRECT
OPENINGS OR ACTIVATIONS.
- RS 485 COMMUNICATION
24Vdc (from the control room)
30 mA
3A – 230 Vac
IP 30
CE
0° to 50°C
-10° to +70°C
5 to 95% with no condensation
Tabla de contenido
