Operating Instructions - Eddy TBE3 Instrucción Y Mantenimiento Manual

Operating instructions

Controls & adjustments
To start removing ceramic tiles, press the Trigger switch and push the chisel on the tiles. Pressing the Triger
switch will activate the tool's motor and the push movement will initiate the impact action.
Depending on the type of tiles and/or to remove mortar, you may have to change the angle of the tool.
To change the angle, press on the Tool angle selector switch up or down until proper angle is set. (See the
picture below).
Chisel selection
WARNING: Always disconnect the power cord before proceeding to the chisel installation or removal.
The Eddy Tile Breaker comes with a complete set of 3 sizes of chisels. You have the option between 1 inch, 2
inch and 3 inch chisels. They are conveniently located at the back of the tool.
Picture of how to unlock the angle selector and how to cover it again
WARNING: only use the 1", 2" or 3" Eddy chisels. These chisels are 8" long and longer chisels are not suitable
and will damage the tool.
Page | 13