Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Preparation
Important: When using an existing outlet box, be sure the box is securely
attached to the building structure and can support the full weight of the fan.
Failure to do so can result in serious injury or death.
1
Step 1
Turn off circuit breakers and wall switch to the
fan supply line leads.
Warning: Failure to disconnect power supply prior
to installation may result in serious injury or
death.To reduce the risk of shock, this fan must be
installed with an isolating wall control/switch.
2
Step 2
Determine mounting method to use.
A. Downrod Mount
B. Angle Mount
Craftmade Part #45AD (see dealer)
IMPORTANT: If using the angle mount
method, check to make sure the ceiling
angle is not steeper than 35°. Angles greater
than 35° will require a 45° angle adapter.
3
Check to make sure blades are at
least 30" from any obstruction.
Check downrod length to
ensure blades are at least
Downrod Installation
(Normal Ceilings)
Downrod Installation
(Vaulted Ceilings)
Step 3
7' above the floor.
84"
(2.1m)
Min.
4
Prior to securing mounting bracket, screw "J" hook (S9) into ceiling
outlet box as a secondary support means. Secure mounting bracket
(#1) to the outlet box (A) by tightening bracket screws & washers (S3)
as shown. If not mounting to an outlet box, use wood screws (S1) and
washers (S3) and mount securely to ceiling beam. Be sure at this
point to insert canopy screws (S2) in bracket.
directly to sheet rock or ceiling tile.
NOTE: J Hook installation is a Canadian requirement only.
"J" Hook (S9)
Ceiling
Bracket Screws
& Washers (S3)
Wood Screws (S1)
5
Step 5
Locate downrod
assembly (#2). Loosen
ball screw on black
hanging ball to free
lock pin. Black hanging
ball will slide down.
Remove ground screw
and green ground wire.
30"
Remove hanging ball
0.75m
Min.
from downrod and save
all parts. Insert fan
wires through downrod.
Screw downrod into top
of fan motor housing,
being careful that wires
are pulled through.
Step 4
NOTE: Do not mount
Support Beam
Outlet Box (A)
OUTLET BOX
Mounting Bracket (1)
Wood Screws (S1)
Canopy Screws (S2)
Lock Pin
Downrod
Assembly
(#2)
Fan Motor Housing
Green Ground
Wire
Ball Screw
Hanging Ball
Downrod
Tabla de contenido
