Tabla de contenido
Gebrauchsanweisungen und Ratschläge
DE
FR
Instructions et conseils
IT
Avvertenze e suggerimenti
- The Carry-Bike CL is an universal bicycle carrier in short version for motorhomes with fl at rear
walls. It is supplied with Bike-Block blocking system and Rail Quick/Premium Rail, it is delivered
as standard for transporting 2 bicycles. Can be upgraded to carry up to 3 bikes by adding a
third Quick Rail. Do not to exceed the max. weight of 55 kg.
- If you exceed the maximum permitted weight, the braking distance of your vehicle will be
increased. Check before you leave.
- Setting the Carry-Bike on rear axis of the vehicle, the standard weight distribution on two axis
could be modifi ed; be sure that it doesn't exceed the maximum permitted load (verify the data
on your own logbook).
- Never exceed the maximum permitted length and the total weight of the full-load vehicle.
- Do not cover the number plate or lights. Repeat lights and plate by using a trailer board if the
Carry-Bike covers them, even partially.
- Before installation, clean carefully the area where the bicycle rack will be mounted and use
rubber protectors in order to avoid any friction, and, consequently, any damages to the body/
paint of the vehicle. Periodically check rubber parts and, in case they are porous or worn,
immediately replace them. If not used for long periods, we suggest to remove the Carry-Bike
from the vehicle.
- Make sure that the support brackets are located where they cannot move or shift sideways.
They also must not touch the roof of the vehicle, the hinges and the corresponding bolts or
screws.
- Periodically check the bicycle rack to make sure it is fi rmly attached, especially during the fi rst
10 km. Make sure the belts are not loose and that the holding brackets have not shifted.
- In case you use the bike cover, pay attention that it is duly fi xed and does not cover the lights.
Detachable parts like child safety seats, bags or air compressor have to be uncoupled and put
away inside the vehicle.
- Bicycles have to be fi xed both with two Quick-Safe (one piece per wheel) and Security Strip
on the frame. Both Quick-Safe and Security Strip have to be periodically checked. In case of
damage, they have to be immediately replaced.
- For extra safety travelling, we suggest using steel cable antitheft device.
- While fi xing the bikes, verify that there is enough distance between handlebars and/or pedals
and vehicle's wall, to avoid compromising the paintwork.
- The load must be evenly distributed (the heaviest bike must be placed near the wall of the
vehicle).
- Be careful when driving and beware of hairpin bends and of gusts of wind. Also keep in mind
that you need a longer braking distance. Beware dangerous road crossing and garage's
entrance. Additional rear view mirrors are required in case of reduced visibility.
EN
Maintenance instructions
ES
Recomendaciones
Carry-Bike
11
Tabla de contenido
