Installation On Luminance Brands Fans Having Two-Piece Die-Cast Switch Housing - Luminance Brands Kathy Ireland Home LK52 El Manual Del Propietario

4. Installation on Luminance Brands Fans Having
Two-Piece Die-Cast Switch Housing
4.1
Disconnect Electrical Power to the Branch Circuit at
the Circuit Breaker Panel or Main Fuse Box before
attempting to install the Ceiling Fan Light Fixture .
4.2
Remove the Two Cover Screws and Cover from the
Switch Housing below Ceiling Fan (Figure 13) .
Retain the Two Screws for future use in Step 4 .6 .
4.3
Carefully pull down the Switch Housing White and Blue
Wires and remove Wire Connectors (Figure 14) .
Retain Wire Connectors for future use in Step 4 .5 .
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box or circuit breaker panel before
wiring. All wiring must be in accordance with National
and Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
SWITCH
HOUSING
SWITCH
HOUSING
COVER
SCREWS (2)
Figure 13
SWITCH
HOUSING
BLUE WIRE
REMOVE
WIRE
CONNECTOR
Figure 14
10
WARNING
FAN
SPEED
CONTROL
CHAIN
WHITE WIRE
REMOVE
WIRE
CONNECTOR
U.L. Model No.: LK52-1