Wet Pick Up Operation - Craftsman CMXEVBCV430L Manual De Instrucciones

19. Or rinse (from the inside of the filter 14 ) with water.
Fig. 11. Dry completely (approximately 24 hours).
Fig. 11
INSTALLING FILTER BAG
Use the filter bag 17 in conjunction with the cartridge filter
14 for easy disposal of the debris. The bag is not required for
normal dry pick up. When picking up fine dust or powders a
high efficiency filter bag (not standard with all models)
must be used. NOTE: For dry use only.

WARNING:
IS DISCONNECTED FROM THE RECEPTACLE,
TANK COVER IS REMOVED AND THE HOSE IS
DISCONNECTED FROM TANK INLET.
20. Grasp carboard collar firmly and slide rubber guard onto
inlet fitting, as firmly as possible. Fig. 12.
Fig. 12
21. When securely in place, expand and position bag 17
around inside of tank. Fig. 13.
Fig. 13
:
17
MAKE SURE THE CORD

WARNING:
EFFICIENCY OF THE VACUUM IS LARGELY
DEPENDENT ON THE FILTER. A CLOGGED FILTER
CAN CAUSE OVERHEATING AND POSSIBLY
DAMAGE THE CLEANER. CHECK THE FILTER
PERIODICALLY AND REPLACE AS REQUIRED.

WARNING:
POWDERS
When vacuuming fine dust, or powders of any kind
(plaster, drywall dust, cold ashes, concrete dust, etc.)
a high efficiency drywall filter bag must be used.
When vacuuming normal household dust and debris,
standard household disposable filter bags may be
used.
22. Check the filter 17 for tears or small holes. If none are
found, reinstall the filter 17 . To prevent damage to this
vacuum, do not use a filter 17 with a hole or a tear.

WET PICK UP OPERATION

23. Your vacuum can be used for wet pick up. Remove ALL
dirt and debris found in the tank. Remove all dry use only
filters, including the filter bag 17 , from this vacuum.
24. A clean cartridge 14 filter may be used to pick up small
quantities of liquid. To use the cartridge filter 14 ; follow
the cleaning and installation instructions under dry pick
up.
25. For vacuuming large quantities of liquid use a foam
sleeve 16 . To use the foam sleeve 16 ; follow the
installation instructions in this section.
26. Misting in the exhaust air or dripping of liquid around the
tank cover may occur if the filter 16 becomes saturated
during wet pick up. If this occurs, remove the filter and
allow to dry, or replace with another dry filter.
27. Turn the unit off immediately upon completing a wet
pick up job or when tank is full and ready to be emptied.
When the tank is full, suction will drastically reduce. Refer
to "automatic suction shut off" in this manual. Raise the
hose 12 to drain any excess liquid into the tank. Follow
the "emptying liquid waste" section in this manual.
28. Before storing the vacuum cleaner or using for dry
pick up, clean and dry the interior of the tank and the
underside of the tank cover. Clean and allow the filters to
dry completely.
NOTE: WET PICK UP ACCESSORIES SHOULD BE WASHED
PERIODICALLY; ESPECIALLY AFTER PICKING UP WET, STICKY
ACCIDENTS. THIS CAN BE ACCOMPLISHED WITH A WARM
SOLUTION OF SOAP AND WATER.
ENGLISH
KEEP FILTERS CLEAN.
FOR FINE DUST
6