Assembly - Blumfeldt Waterbirds Manual Del Usuario

ASSEMBLY

1. Unpack the contents of the box and check to make sure that all items are
accounted for and in good condition.
2. Select a flat, even surface for the assembly and final location of your
fountain. Place the fountain on an insensitive surface. It can come to
splashing water. For any damage to carpets, laminate, parquet or anything
else, we assume no liability.
3. Run the cord from the pump through plastic tube at the fountain basin
reservior and out the base, making sure to place the pump in the center of
the reservior. (1)
4. Carefully attach the water supply tube located from top cover to the pump
outlet on top of the pump. Then connect the male jack with female jack of
LED light. (2)
5. Insert birds into fountain base. Add clean water into the basin. The water
level should be approximately 1 inch lower than the top edge of the basin.
(4)
6. Connect the pump power cord to an outlet and the product will begin to
function as intended. (5)
7. To eliminate the possibility of water damage around your fountain, check
for leaks and excessive splashing after the initial setup of your fountain.
It is highly recommended that this fountain be placed in an area where it
cannot be damaged.
8. Do not leave your fountain running for extended periods of time when no
one is present to observe the performance.
9. Please refresh the fountain with water each week to ensure it in good
condition.
10. Do not allow the pump to run unless it is covered with water.
The diagrams shown are for illustrative purposes only.
EN
9