Installation Methods - Kenwood KS-3100EX Manual De Instrucciones

Installation Methods

On Floor or Shelf
Place the speakers on the floor or on a shelf or other horizontal stable surface. Keep in mind that speakers are not fixed into
place, so be careful to avoid knocking them over.
On the Wall
The speakers include mount holes for wall mounting. You can hang the front and surround speakers on the wall vertically, and
the center speaker horizontally. For vertical mount, you use only one screw and hang the speaker from its upper mount hole
only. For horizontal mount, you need to set two screws into the wall at the appropriate distance so that you can hang the
speaker from both mount holes.
To hang a speaker vertically
1. Screw a single screw into the wall at the desired
location. Screw it only part way in, so that the screw
projects 8 to 10 mm (5/16 to 3/8 inches) outward from
the wall surface.
2. Hang the speaker by fitting the top mount hole (at the
upper rear of the speaker) over the extending part of
the screw. Confirm that the speaker is held firmly and
securely in place.
To hang a speaker horizontally
1. Screw two screws into the walls 94 mm (3-11/16
inches) apart, making sure that screws are horizontally
level. Screw each screw only part way in, so that the
screw projects 8 to 10 mm (5/16 to 3/8 inches) out-
ward from the wall surface.
2. Hang the speaker by fitting the two mount holes (at
the rear of the speaker) over the extending part of the
screw. Confirm that the speaker is held firmly and
securely in place.
Precautions
Please observe the following precautions when mounting speakers onto the wall.
• Be sure that the wall you are using is strong enough to support the full weight of the speaker (approx. 0,9 kg [2.0 lb]).
• Wall screws must be purchased separately. Be sure to use screws that are appropriate for the wall you are using, and that
are long enough to provide sufficient strength.
• If you are uncertain about the wall's support strength, the type of screw to use, or any other points regarding this type of
installation, please consult a contractor or other qualified person before proceeding.
Be sure to follow the procedure given here when carrying out installation. Kenwood can assume no liability for injury
or damage that may occur if a speaker setup falls from the wall as a result of incorrect installation or insufficient
support strength.
On the speaker stand
The speaker can be installed on the SR-8000 stand optionally
available from KENWOOD.
Front and Center speaker only; Any commercially available
stand can also be used (provided that the rear of the stand can
be fixed using an M5 screw with a pitch of 60 mm and effective
thread length of 7 to 10 mm).
For details, read the instruction manual for the stand.
M5 screw
4
EN
Effective thread
length
8 - 10 mm
(5/16 - 3/8")
8 - 10 mm
(5/16 - 3/8")
Attaching the cushions
Attach cushions to the base of the speaker as shown below.
The cushions prevent the speaker from sliding, and dampen
its vibrations.
Front speakers,
Surround speakers
94 mm
(3-11/16")
Center speaker