Commissioning; Special Safety Instructions; Electrical Requirements; Uv-C Light Bulbs - MANN+HUMMEL OurAir TK 850 Manual De Instrucciones Original

Commissioning

6 COMMISSIONING

6.1 Special safety instructions

CAUTION!
When connecting the appliance, observe the basic safety instructions in
section 2.1 on page 6.
Every OurAir TK 850 indoor air purifier has to pass a quality inspection before it leaves
our factory. How-ever, we have no control over any minor errors that may occur during
shipping and handling.
We recommend that you check the following critical components before using your air
purifier.
6.1.1

Electrical requirements

WARNING: ELECTRICAL VOLTAGE!
Using an unsuitable electrical supply for the appliance can lead to severe or fatal
injury!
– Only use the power cord supplied with the appliance!
– Ensure a suitable and safe power supply for the appliance!
– Operation is only permitted in circuits with residual current operated circuit-breaker
(RCCB)!
– To avoid personal injury, fire hazards and/or damage to the electrical system and the
appliance power cord, the appliance may only be connected to or disconnected from
the power supply when the fan and the UV-C lamps* are switched off!
– The OurAir TK 850 requires a power supply of 220 – 240 V ~ at 50 / 60 Hz for correct
operation.
– Only use extension cables with CE certification and the GS mark ("Geprüfte
Sicherheit").
– Do not use multi-socket extenders for the power connection!

6.1.2 UV-C light bulbs*

CAUTION!
Defective or incorrectly installed UV-C light bulbs can damage the appliance and
impair the purification performance.
– Do not operate the appliance with UV-C light bulbs that have obvious signs of external
damage.
– Before commissioning the appliance, make sure that the UV-C light bulbs are
undamaged and correctly installed!
– Only touch the light bulbs by their end parts. Never touch the glass of the light bulb.
Otherwise the effectiveness of the light bulbs will be impaired!
* Applies to models with integrated UV lamps
16 – EN

6.1.3 Filter elements

CAUTION!
Defective or incorrectly installed filter elements impair the cleaning performance of
the appliance! Before commissioning the appliance, make sure that the filter elements
are undamaged and correctly installed!
– Make sure that the pre-filter is correctly installed and undamaged.
– Note the correct flow direction, marked by a symbol on the side of the pre-filter.
– Make sure that the cover of the pre-filter housing is closed properly.
– Open the lid of the housing and check the HEPA filter for damage to the material or
structure. Close the lid of the housing securely and remove the key.

6.2 Power supply

1. Plug the supplied power cord into the integrated plug socket on the rear of the device
(see Fig. 4, item 7 on page 13).
2. Take hold of the plug to plug the power cord into the power socket (or a suitable extension cable).
3. Switch on the appliance using the power switch next to the plug socket
(see Fig. 4, item 7 on page 13).
4. The appliance starts and shows the start screen on the LED display.
5. Use the LED touch screen to operate the various functions of the appliance.
Commissioning
EN – 17