Idiomas disponibles
Idiomas disponibles
3.El compresor se calienta en verano durante la operación de congelación.
4.Calor alrededor del marco puerta esnormal.
La capacidad neta del congelador (litros) ha sido testado sin los cajones del congelador.
Diagrama
Transportation and Handing
When moving the unit, always hold the base, and lift carefully while keeping the unit upright. The
unit should never be tilted beyond 45 degrees, placed upside down, or laid on its side, back, or front.
Never hold onto the door for support while moving the unit. It may damage the hinges.
Installation
1. Place the freezer on a flat, firm surface. This will help eliminate noise
caused by vibration.
2. Choose a well ventilated area. There should be at least 10 cm of open space along the sides,
top, and back of the freezer.
3. Select a location which is away from heating sources, direct sunlight, ovens, etc. Also, the
area should be dry, and free of damp, stale air.
Testing
1. Clean the freezer with lukewarm water and detergent, and wipe dry. Notes: Electrical
components should be cleaned with a dry cloth.
2.Turn the thermostat knob to the "2" position, and plug the freezer into the wall outlet. The
compressor will begin to run.
3. Check, after 30 minutes of operation, to ensure that the freezer is cold.
Temperature Control
1.The temperature control (thermostat knob，turned by coin) is located near the top of the unit.
