2. Move the choke lever to the choke position.
WARNING: The cutting attachment
starts to rotate immediately when you
start the engine with the choke.
3. Hold the body of the product on the ground with your
left hand.
4. Hold the starter rope handle with your right hand and
the throttle trigger and throttle trigger lockout with
your left hand.
5. Slowly pull out the starter rope with your right hand
until you feel some resistance.
WARNING: Do not twist the starter rope
around your hand.
6. Pull the cord quickly and with force. Pull a maximum
of 5 times.
CAUTION: Do not pull the starter rope to
full extension and do not let go of the
starter rope handle when the starter rope
is fully extended. This can cause
damage to the product.
7. Reset the choke when the engine fires.
8. Pull the starter rope again and again until the engine
starts.
9. Operate the throttle gradually when the engine
starts.
10. Make sure that the engine runs smoothly and let the
engine become warm for 1-2 minutes before
operation.
10
To stop the product
•
Push the stop switch to stop the engine.
WARNING: The stop switch automatically
goes back to start position. To prevent
accidental start, remove the spark plug cap
from the spark plug when you assemble or
do maintenance on the product.
Grass trimming with a trimmer head
To trim the grass
1. Hold the trimmer head immediately above the
ground at an angle. Do not push the trimmer line into
the grass.
2. Decrease the length of the trimmer line by 10-12
cm / 4-4.75 in.
3. Decrease the engine speed to decrease the risk of
damage to plants.
4. Use 80 % throttle when you cut grass near objects.
1559 - 003 - 01.10.2020