Air Filter - Domo DO263A Manual De Instrucciones

Drain code P1
When you don't use the permanent drain, the non recycled condesation water, will be stored
in the water tank.
· When the water tank is full a few beep signals will be heard
and on the display the code P1 will appear. The "cool" or "dry"
mode will end automatically. The fan will continue to operate,
this is normal.
· Move the unit over to a place where you can easily drain the
water.
· Remove the drain plug at the bottom of your unit (A) and
drain the water.
· After fully draining the water tank, place the drain plug back
on the drain opening.
· Restart the unit, make sure the error code P1 is no longer
displayed. When the code doesn't disappear, try turning off
and on the unit a few times. When the error code continues,
please contact the after sales service.
· NOTE : always make sure to install the drain plug, before
turning the unit back on.
CLEANING
· Always remove the plug from the socket before cleaning the unit.
· Never use any chemical or abrasive products to clean the unit.
· Never clean the unit with water or any other liquid, this can cause electrocution.
· When the power cord is damaged it must be repaired or replaced by the after sales surface
of the manufacturer or by a qualified person.

Air filter

· Clean the air filter at least ever 2 weeks. To make sure the
airco can operate in optimal conditions.
· Clean the air filter in lukewarm water with a bit of
detergent. Rinse the filter thoroughly and let it dry.
· Make sure the filter is completely dry before placing it
back in to the airco.
Airco body
Use a damp, soft cloth and a bit of mild detergent, to clean the outside of the unit. Make sure
the unit is thoroughly dried afterwards.
www.domo-elektro.be
A
57
DO263A