HQ-Power HQLP10030 Manual Del Usuario página 9

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
6.4
Master/Slave Mode
The master/slave mode allows for connecting several devices to a single master device
in a daisy chain.
All slave devices will then work synchronously with the master device.
Configure all slave units before connecting the master unit to the daisy chain.
6.5
DMX Mode
The DMX mode allows you to control the device with any universal DMX controller.
All DMX-controlled devices need a digital start address so that the correct device
responds to the signals. This digital start address is the channel number from which
the device starts to "listen" to the DMX controller. The same starting address can be
used for a whole group of devices or an individual address can be set for every
device.
When all devices have the same address, all the units will "listen" to the control
signal on one particular channel. In other words: changing the settings of one
channel will affect all devices simultaneously. If you set individual addresses, each
device will "listen" to a separate channel number. Changing the settings of one
channel will only affect the device in question.
DMX Channel Values
Refer to page 3 of this manual.
6.6
Remote Control
Black Out
Press this button to black out the current active mode. Press again to return.
Auto
1.
Press <AUTO>.
2.
Press <+> or <-> to choose the different programmes.
Sound
1.
Press <SOUND>.
2.
Press <+> or <-> to choose the different programmes.
Strobe
1.
Press <STROBE>.
2.
Press <+> or <-> to choose the different programmes.
Speed
1.
Press <SPEED>.
2.
Press <+> or <-> to adjust the programme speed.
Sensitivity
1.
Press <SENSITIVITY>.
2.
Press <+> or <-> to adjust the microphone sensitivity.
DMX/%
Allows you to activate/de-activate the DMX mode.
Manual
1.
Press <MANUAL>.
2.
Press <R>, <G> <B>, <W>, <A> or <UV> to select your colour.
3.
Press <+> or <-> to select the static colours.
Fade
Press <FADE> to enable or disable the fader.
1-9
Press <1> to <9> to adjust the colour intensity.
V. 03 – 15/10/2018
HQLP10030
9
©Velleman nv
Tabla de contenido
loading

Tabla de contenido