Features - Get To Know The Main Parts Of Your Dryer; Where To Put And Vent Your Dryer; How To Use Your Dryer - Indesit IS30V Instrucciones De Instalación, Uso Y Mantenimiento

Features - Get to know the main parts of your dryer

Heat Selector Switch
Filter Assembly
(on inside of the door)
Exhaust Air Grille

Where to put and vent your dryer

Your tumble dryer should NOT be located adjacent to a gas hob,
cooker, heater, or eye level grill as flames from the burners could
cause damage to your machine.
The dryer should be placed where air can freely circulate around
it, preferably near a window that can be opened to reduce the pos-
sibility of condensation occuring while the dryer is in use.
When operating the dryer, there has to be adequate ventilation to
avoid the back flow of gases into the room from appliances
burning other fuels, including open fires.
A vent hose is recommended for optimum performance.
DO NOT operate the dryer in an enclosed environment,
ensure the dryer is adequately ventilated.
DO NOT allow clothes, towels etc., to hang down the front of
the dryer into the airstream. This obstructs the airflow and
may damage the dryer.
Ensure that the end of the hose is not directed towards the
air intake grille at the rear of the dryer.
NOTE: The vent hose should not exceed 2.4 metres in length,
and should be kept free of any possible accumulation of fluff
lint (and water) by frequently shaking it out. Always ensure
that the hose is not squashed.
Window Vent Kit A venting kit is available as an optional extra, which will take the moist
air directly from the dryer and out through an open window.
The venting kit is fitted to the front of the door.
Wall Hanging Kit This allows the dryer to be mounted on a wall of suitable strength to
take the weight. Alternatively it should be used when the dryer is
mounted on top of a work surface to secure the dryer to the wall.
WARNING:
DO NOT DISCHARGE THE EXHAUST AIR INTO A FLUE WHICH IS
USED FOR EXHAUSTING FUMES FROM OTHER APPLIANCES
BURNING GAS OR OTHER FUELS.
Mains On/Off
Indicator Light
(if fitted)
Timer Knob
Door Release

How to use your dryer

1. Plug in, switch
on electricity.
WARNING: WHEN
SWITCHING ON
OR OFF, PLEASE
ENSURE THAT
YOUR HANDS
ARE DRY
3. Open the door.
Check that the fluff
filter is clean (see
section How to
remove and clean
the fluff filter).
5. Select the
relevant heat setting
(see section "Sorting
your Laundry").
Push IN for full heat, for cottons, linens and
synthetics.
Low setting - button OUT for acrylics and
acrylic mixtures.
6. Turn the Timer
clockwise to select the
required drying time.
(See Section "The
Controls".)
The dryer will start
7. When finished
open the door and
take out the laundry.
Clean and replace
the fluff filter.
Never switch the dryer off with a hot load in the drum.
You must terminate every programme with the Cool Tumble Phase.
2. Sort your laun-
dry (see section
"Sorting Your
Laundry")
4. Load the dryer
placing the clothes
carefully in the
drum, pushing
them well towards
the back and away
from the door seal.
Close the door.
Button OUT
LOW HEAT
Button IN
HIGH HEAT
8. Switch off electricity
WARNING: WHEN
and remove plug from
SWITCHING ON
socket.
OR OFF, PLEASE
ENSURE THAT
YOUR HANDS
ARE DRY
3