VOX electronics SCIROCCO 700 Manual De Usuario página 7

Maintenance
1. Change the dust bag: when the dust full indicator turns red or loss of suction is noticed, it is time to clear the
dust bag or replace with a new bag.

Open the front cover by touching front cover button.

Take out the bag holder then remove the full dust bag.
Installing the dust bag: insert the dust bag into the bag holder and then put it in the slot cabinet.
Note: If the dust bag is not installed, the front cover can't be closed
2. Inlet filter: clean the filter with warm water and allow to dry fully before placing back into the unit.
Replacing the inlet filter: clip down and remove the inlet cover, remove and replace with a suitable filter.
(Fig 15)
3. Clean the outlet filter: open the outlet cover and take out the HEPA frame and filter. Wash it and install it after
the filter has fully dried.
Fig 10
Fig 13
Fig 16
Warning
The plug must be removed from the power socket before any maintenance or replacement.
If the power cord is damaged, it must be replaced by the manufacturer or its service agent or an appropriately
qualified person in order to avoid a hazard.
(Fig 10)
(Fig 16/17)
(Fig 11)
(Fig 12)
Fig 11
Fig 14
Fig 17
(Fig 13)
(Fig 14)
Fig 12
Fig 15