Installing The Lever; Attaching The Lance To The Trigger Valve (Starting And Stopping); Tightening The Fastening Nut; Adjusting The Shoulder Strap - Jacto XP-12 Manual Del Operador

3.3. Installing the lever

• Lightly greases the orifice on the chamber top.
• Fit a flat washer on the shaft and rod.
• For easy assembly, install the lever on the shaft and the rod on
the chamber top at the same time.
• Install the other flat washers on the shaft and rod and lock
with the lock ring.
Locked
Rod
Lever
Locked ring
Flat
washers
3.4. Attaching the lance to the trigger valve
(starting and stopping)
• Push the lance into the trigger valve and secure it with the
screw cap.
Trigger
valve
Lance
WARNING!
Do not overtighten the screw cap.

3.5. Tightening the fastening nut

• Before using the equipament, tighten the fastening nut (A).
A
4/68
NOTE: This operation must be done with the hand. Do not use
any type of tool.

3.6. Adjusting the shoulder strap

• The tank is contoured for the operator comfort. The shoulder
straps can be quickly adjusted to properly position the spray-
er on the operator's back.
ring
Shaft

3.7. Tightening

• Hold the strap buckle firmly with one hand, and pull the han-
dle downward with the other hand.
A
Handle

3.8. Loosening

• Hold the buckle firmly with one hand, and pull the strap up-
ward with the other hand.
B
Buckle

3.9. Storage

The sprayer should be stored in secure and ventilated place.
Do not store equipment with syrup in the tank. The chemicals
can cause different reactions and damage components of the
equipment and the health of the operator. Store sprayers mainly
in harsh winter locations.
CAUTION!
TRANSPORTATION: The sprayers can not be
carried along with food, beverages, pharma-
ceuticals, feed, animals and people without
adequate equipment (PPE).

4. Operation of Product

4.1. Recommendations for use

This equipment must be used only with products to protect
plants approved for knapsack sprayers.
Do not use acids or flammable liquids. After assembling the
sprayer, fill the tank with clean water and check for leakage on
the following parts. After the use of herbicides clean the equip-
ment before using other formulations.
4.1a. Best spraying practices
Buckle
Correct volume of water
Correct nozzle
Constant walking speed
Sprayer cleaning and main-
tenance
4.1b. Application
Wear appropriate protective clothing
Correct proportion of product
Do not contaminate water
Constant pressure
Uniform spray height
5/68