Rear Panel; Remote Control - Marq HAZE700 Guia Del Usuario

Features

Rear Panel

1. Cap: Twist this cap clockwise to tighten it or counterclockwise
to loosen it. The tube that passes through its center feeds the
fluid in the tank to the heater.
2. Tank: Fill this tank with a high-quality, water-based haze fluid
only. Using non-water-based fluids with this product will void
its warranty.
3. Fluid Level Indicator: This transparent part of the tank shows
its current level of fluid. If this approaches the Low reading, fill
the tank with the recommended water-based haze fluid.
4. Power Cord: Connect this attached power cord to a power outlet.
5. Fuse: If the fuse is broken, disconnect the power cord from
the power outlet, and then unscrew this holder to replace the
fuse. Replace it with a fuse with an appropriate rating (printed
under on the rear panel). Using a fuse with an incorrect rating
can damage the product and/or fuse.
6. Power Switch: Use this switch to power Haze 700 on or off.
After powering it on, wait for 2–3 minutes until the heater is
warmed up and the Ready light on the remote control
illuminates.
7. Remote Control Input: Connect the remote control to this input.

Remote Control

1. Power Switch: Use this switch to power the remote on or off.
2. Power Light: This light will illuminate when Haze 700 is
powered on. After powering it on, wait for 2–3 minutes until
the heater is warmed up and the Ready light on the remote
control illuminates.
3. Ready Light: This light will illuminate when Haze 700 is
warmed up and ready to use.
4. Output: Turn this knob to control the amount of haze (0–100%).
4
1
7
3
6
5
4
4
3
1
2
2