Astralpool Brick Light Serie Manual De Instalación Y Mantenimiento página 3

Operation modes
The COLORPLUS ECO unit enables different light scenarios to be created with two operation possibilities:
Set colour: Selection of one set colour out of seven possibilities.
Automatic sequence of colours: Selection of nine colour sequence programmes. Each programme is defined by the lighting time of each colour
and the transition time from one colour to another according to the following table:
The colour or sequence is changed by pressing the pushbutton. The colour and sequence cycle is rotary. For example, if you are in colour 5, by
pressing once, you will reach colour 6. If you press once again, you will go to sequence 7. If you are in sequence 7, press once and you will get
to colour 2, which is Red.
Colour 1, corresponds to white and is reached by one long press.
4.2.B. COLORPLUS TOP: Modulator control and/or Remote control
The system has 20 operation modes: 12 set colours and 8 sequences of different colours.
The Modulator controls switching the lamps on and off, changes of colour and sequences and switching off timing.
Electrical connection diagram
For correct installation, you will need the Modulator, the transformer and
finally the leds lamp. As an option, this system can be controlled by
Remote Control. For more information on the installation of the
Modulator, see point 4.2.3. and section 4.2.4. includes information on
the Remote Control.
The Modulator is connected to the 230 V~AC mains by means of two
terminals indicated MAINS, and to the primary input of the transformer
(230 V~AC) by means of the terminals indicated TRF (See attached
diagram).
Each Modulator, it can control until a maximum of five spotlights.
The transformer must have the capacity to supply 10 VA to each Brick
connected. For example, if you want to control 5 Brick lights, they
should be connected in parallel to a transformer of at least 50VA.
Each Modulator can control up to a maximum of 90 LED spotlights.
Once the unit is connected, proceed as follows to start-up the Brick light for the first time:
• Switch on the unit by activating the 230 V~AC. at the input of the Modulator, which will automatically syntonize with the transformer. The
green led of the Modulator will flash every 2 seconds and the lamp will remain off.
Types of lighting
The Remote Control –Modulator – Transformer – Led Brick light unit enables you to create different lighting settings inside the pool with two
operation options:
Set colour: Selection of a set colour among twelve possibilities.
Automatic sequence of colours: Selection of eight colour sequence programmes. Each programme is defined by the lighting time of each colour
and the transition time from one colour to another according to the following table:
COLOUR Nº
1
2
3
4
5
6
7
SEQUENCE
1 Red Blue
2 Red Green
3 Purple Cyan
4 Red Blue
5 Purple Cyan
6 Yellow Purple
7 Green
1 Red
2 Green
3 Blue
4 Yellow
5 Cyan
6 Purple
COLOUR
White
Red
Blue
Green
Purple
Cyan
Yellow
ORDER OF COLOURS
Green Purple
Cyan Blue
Yellow -
Green -
Yellow -
Cyan -
Red Blue -
7 Sky-blue
8 Pale Violet
9 Orange
10 Magenta
11 Emerald green
12 White
3
Cyan Yellow
Purple Yellow
- -
- -
- -
- -
- -
~ ~