Checking The Operator Components; List Of Components (B4); Preparing The Mounting - Aprimatic ZT42 Serie Instrucciones Para La Instalación

Preliminary operations
2.2

CHECKING THE OPERATOR COMPONENTS

Also check that the model code displayed on the operator packaging
corresponds to the code on the identifi cation plate of the operator
itself (B3).
Also, before starting with the mounting procedure, check that the
packaging contains all the components listed in fi g. B4 on the next
page, and that none of the components are damaged.

2.2.1 List of components (B4)

1 - Operator
2 - Upper cover
3 - Release lock
4 - Nut
5 - Ball joint
6 - Snap ring
7 - Rod protection casing
8 - Rod protection casing cover
9 - Rear mounting
10 - Bushing
11 - Rear pin
12 - Snap ring
13 - Fork pin
14 - Fork
15 - Locknut
16 - Capacitor
17 - Front mounting
18 - Self-tapping screw
19 - Template
20 - Release key
21 - Seal
A - Complete front mounting assembly
B - Complete rear mounting assembly
2.3

PREPARING THE MOUNTING

To mount the operator, a number of preparatory on-site jobs need
to be done on the structure that is to be moved; for this, it is better
to be equipped with the correct tools, so that the installer is able
to work independently.
Caution
The list of required tools is shown in the illustration and
table (B5).
Electric disk grinder - 230 V
Protective goggles
Electric welder - min. power: 230 V/100 amp
Protective mask
Electrodes - min. Ø 2
Soldering iron
Suitably powered electric drill - 230 V
Drill bits
Hollow cutter Ø 67 for photocell and control panel mounting holes
Extension lead for welder
Electric cable, cross-section 1.5 mm
of cable terminals
Electrical scissors
Pliers for cable terminals
Tester
1/20 gauge
Rule
Detergent wipes
Paper hand-towels
B5
2
2
6 5 4 7 3
2 ,various colours +various types
1
- 16 -
B3
B4
1112 13
9
10
14 15 18
6
4 5
17
First aid kit
Goniometer
Dynamometer
Plumb line
Spirit level (3-D)
Graphitized grease
Oil -AprimOil HC 13 (specially formulated for Aprimatic)
Zincospray cylinder
Anti-rust paint
Paintbrushes
Thinner for cleaning paintbrushes
Wire brush
Various fi les
Hacksaws
Scribers
Hammer
Chisel for steel and masonry
POS. TOOL
1 Screwdriver
2 Gripper for snap ring on shaft
Screwdriver TC
3
Combined wrench 12
4
5 Combined wrench 13
6 Combined wrench 14
7 Combined wrench 17
20
2
3
1
12
B
8
18
7
A
16
USAG 326/5x150
USAG 128 P/10÷25
USAG 326 TC/2
USAG 285/12
USAG 285/13
USAG 285/14
USAG 285/17
R