Regent WZT1500 Manual De Instrucciones página 4

WZT1500 I.S. 325-1394
Step 3: To mount each light fixture to the light bar. First,
lay fixtures face down on a smooth flat surface.
Make sure that the junction box connecting the fixtures and cords are positioned as shown in
figure B. Place bolt through the square holes in
the crossbar, and then place the bolt through the
bracket on the fixture. Place washer onto the bolt
and tighten the plastic knob until secure.
Repeat for opposite fixture.
Step 4: To install the wire safety guard,
insert one side of the guard
between the frame and lens.
Squeeze the guard until the other
side can be placed between the
opposite side of the frame and lens.
Step 5: To attach the light assembly bar to the adjustable
pole, position the hole in the middle of the light
assembly bar over the threaded screw on the pole.
Note: The large hole in the light assembly bar should be
facing down to fit over the nut already in place. Once the light
assembly bar is in place, position the hole in the junction box over
the threaded screw. Secure with attachment knob.
How to Use:
Step 1: Loosen the knob at the top of the leg assembly
and pull legs out, extending to full open position
so that the top black bracket slides down until it
meets the bottom bracket. Set the stand on a
flat surface and release the center pole. Loosen
the knob at the top of the leg assembly and pull
legs out, extending to full open position so that
the top black bracket slides down until it lines up with red line on
label (Figure A).
Step 2: Plug light into a GFCI protected 120-volt receptacle.
Step 3: Adjust the tripod stand to the desired height by loosening and
tightening the locking collars on the pole.
Step 4: To turn light ON, or OFF, push red switches on the back of each
fixture. Each fixture has two switches for the following light output.
• Left Button - 500-watt setting
• Right Button - 250-watt setting
• Both on - 750-watt setting
Turn light OFF by pressing each switch a second time.
Step 5: When worklight is used on uneven terrain, extend the adjustable
leg out as necessary to properly balance the worklight. To extend
adjustable leg, loosen locking collar on leg and extend leg as
required. Tighten locking collar to secure in place. NOTE: Tripod
legs should be staked to the ground or secured with sand bags or
other suitable weight.
10/28/03 3:41 PM Page 4
4
Slide bracket down
to line up with RED
mark on label
LABEL
Fig. A
Fig. B
Regent
Slide bracket down
to line up with RED
mark on label
LABEL
Fig. A