Phonic WM Serie Manual Del Usuario página 8

WM60 TRANSMITTER
Front Panel
4
WIRELES
SIG/CL IP
1
1. Sig/Clip Indicator – the LED indicator will
light up green when a signal is being re-
ceived by the WM60 transmitter. It will turn
red when the signal level becomes exces-
sive, just 4dB before clipping.
2. Channel Selector – adjusting this dial
to one of the preset channels allows the
WM60 to know which frequency to send
the wireless information at. The wireless
receiver should be set to the identical chan-
nel if transmission is to occur successfully.
3. On/Off Button – this button turns the
WM60 on and off.
4. Antenna – this is the WM60's antenna. Ad-
just it so it sits in a vertical position when
the device is in use (change the position
if the wireless signal quality is poor). Push
the antenna in to release it before adjust-
ing its position.
Rear Panel
5. 1/4" Input – this jack accepts balanced
and unbalanced /4" inputs from line-level
sources.
7
DC IN
8
WM6
S T RA NSMITTE R
ON OFF
2 3
5
6
I NPU T
6. XLR Input – this jack accepts balanced
XLR inputs from line-level sources. Both
the /4" jack and the XLR jack run in par-
allel.
7. DC In – plug DC end of the supplied DC
power adaptor into this jack, and the other
end into a suitable AC power source to al-
low the WM60 to be powered. Please en-
0
sure you use the DC power supply (2V,
300mA) provided with this unit, as using
another power supply could cause dam-
age.
WM70 TRANSMITTER
Front Panel
1. Left and Right Sig/Clip Indicators – the
LED indicator will light up green when
a signal is being received by the WM70
transmitter. It will change to red when the
signal level becomes excessive, just 4dB
before clipping.
2. Trim Control – these controls adjust the
level of the signal received via the Combo
inputs on the rear that will be sent wire-
lessly.
3. Channel Selector – adjusting this dial
to one of the preset channels allows the
WM70 to know which frequency to send
the wireless information at. Each preset
channel will transmit both the left and right
signals, so that the WM40-L, WM40-R,
WM400(D)-L and WM400(D)-R wireless
receivers (if set to the identical channel)
will receive the signal successfully.
WM SERIES