Installation Instructions - Vin sur Vin VSV12F Manual De Utilización

4. INSTALLATION INSTRUCTIONS

Before using your temperature control cellar
•
Remove the inner and outer packaging.
•
Allow the appliance to rest for two hours before switching it on.
•
Clean the inside using a soft cloth and lukewarm water.
Using your temperature control cellar:
The appliance must be positioned in a room with an ideal ambient temperature of 25°C.
If the ambient temperature is higher or lower, the appliance's performance may be affected.
Installing your temperature control cellar:
•
This appliance is designed for free-standing installation.
•
Position it in a place with sufficient strength to support its weight when loaded. To ensure that it is level,
adjust the height of the feet underneath.
•
To get the best from your appliance with the lowest energy consumption, do not place the appliance
close to a heat source (heater, cooker, etc.), do not expose it to direct sunlight, and do not place it in a
room which is too cold.
•
Connect the appliance to a single socket, leaving a 10 mm gap between the back of it and the wall and 2
cm on each side. Be careful to support it, so that it is perfectly level. (Use of a spirit level is
recommended). This will prevent any movement due to instability, causing noise and vibration, and will
ensure that the door seals perfectly.
Selecting the temperature
•
You can choose the desired temperature in the compartment, using the
selected increases/decreases by 1°C with each button press.
This appliance belongs to category 10 according to the european regulation N°1060/2010. The temperature
setting is from 14° to 18°C.
However the appliance's technical performances allow to reach a wider temperature range from 12° to 18°C.
The interior light may be switched on or off using the
/ buttons. The temperature
button.
16