Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3.
PLACING
OPTIONAL CERAMIC LOG AND OPTIONAL PEBBLES SET
3.1 Fitting the Ceramic log set (see APPENDIX7)
*
Mix the glowing material (lava granules) and spread them evenly over the burner and the burner
plate so that they are just covered. Glowing embers can be placed here and there as decoration.
*
Place the ceramic wood blocks in the correct order as shown on APPENDIX 7.
*
Place the logs carefully. Other location can seriously affect the flames or malfunction of the
burn process (sooting)
*
Before replacing the windows make sure if there must be a restriction plate to be placed or not.
See chapter 7 "Concentric chimney lay out"
*
If there is a restriction required for your situation, remove the baffle plate by unscrewing it
from the front of the plate and move the plate backwards and then out. Now install the restriction
plate with two screws and replace the baffle plate. (Also see APPENDIX 5-7).
*
Now place the window in reverse order as described at
on APPENDIX 5.
Note:
when installing the log and Pebble set and the various glowing materials and accessories, the fol-
lowing must be taken into account:
A:
No glowing material in or on the pilot burner.
B:
Prevent that ceramic material falls on the glass seals. Remove this if necessary. The window can be damaged.
Slot /opening between burner and mesh deco plate must be kept free of glowing material. Too much
C:
placed glowing material can affect the combustion process.
3.2
Fitting the optional Pebble set. (see appendix 8)
*
Scatter vermiculite evenly over the burner tray. Make sure the pilot light remains unobstructed.
*
Place a row of medium-sized and large pebbles at the front of the burner plate
*
Fill the burner tray with small and medium-sized pebbles from the front to the rear.
Place the pebbles as closely as possible to each other on the burner tray.
*
Fill the rear of the burner plate with medium-sized and large pebbles.
*
Before replacing the window make sure if there must be a restriction plate to be placed or not.
See chapter 7
"Concentric chimney lay out"
*
If there is a restriction required for your situation, remove the baffle plate by unscrewing it
from the front of the plate and move the plate backwards and then out. Now install the restriction
plate with two screws and replace the baffle plate. (Also see Appendix 5, pictures 7).
*
Now place the window in reverse order as described at chapter "PLACING THE APPLIANCE" 2.2 and
on Appendix 5.
NOTICE
MAKE SURE THE PILOT LIGHT REMAINS UNOBSTRUCTED FROM ANY MATERIAL!
chapter "PLACING THE APPLIANCE"
2.2 and
Page.5
Capítulos
Tabla de contenido
