Kicker ZX.5 Serie Manual Del Propietário página 3

The ZX amplifi er has dual input sensitivity differential RCA inputs which will receive either high or low level signals
from your car stereo's source unit. A high-level signal can be run from the source unit's speaker outputs to the
stereo RCA input on the end panel of the amplifi er using the KICKER ZISL as shown (make sure you set the ZX
amplifi er's input level switch to "HI"). Alternatively, the signal can be delivered to the amplifi er using the low-level
RCA outputs on the source unit. Set the input level switch on the end panel of the amplifi er to "LO". Keep the
audio signal cable away from factory wiring harnesses and other power wiring. If you need to cross this wiring,
cross it at a 90 degree angle.
core conductor
source unit
high-level speaker
outputs
+
–
Install a fuse within 18" (45cm) of the battery and in-line with the power cable connected to your amplifi er. If you
ever need to remove the amplifi er from the vehicle after it has been installed, the ground wire should be the last
wire disconnected from the amplifi er--just the opposite as when you installed it.
Model External Fuse
ZX700.5 1 x 100 Ampere
GND REM +12V
24"
(60cm)
bare-metal
chassis ground
2011 ZX 700.5 RevB.indd 3 2011 ZX 700.5 RevB.indd 3
to amplifi er
shield
Power/Ground Wire
4 Gauge
remote turn-on
(see page 5)
KICKER ZISL
OR
source unit high-level
speaker outputs
KICKER Wiring Kit
PK4, CK4, ZCK4
protection LED
18"
(45cm)
external fuse
12V
to amplifi er
battery
3
10/12/2010 10:41:52 AM 10/12/2010 10:41:52 AM