Rear Panel - Crest Audio Pro-LITE 5.0 Manual Del Propietário

Rear Panel

10
AC POWER INLET:
10
This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to this
connector to provide power to the unit. Damage to the equipment may result if improper line voltage is used. (See line
voltage marking on unit).
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a
ground pin, a suitable grounding adapter should be used and the third wire should be grounded properly. To prevent the
risk of shock or fire hazard, always make sure that the amplifier and all associated equipment is properly grounded.
NOTE: FOR U.K. ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings
identifying the terminals in your plug, proceed as follows: (1) The wire which is colored green and yellow must be
connected to the terminal which is marked by the letter E, or by the Earth symbol, or colored green or green and
yellow. (2) The wire which is colored blue must be connected to the terminal which is marked with the letter N, or the
color black. (3) The wire which is colored brown must be connected to the terminal which is marked with the letter L,
or the color red.
THRU/OUT JACKS
11
This XLR jack supplies parallel output signals from the associated channel for patching to this amplifier and/or
additional power amplifier inputs. This XLR jack also provides an unbalanced (tip/sleeve) output to be patched with
single-conductor shielded cables.
CONNECTING INPUTS
12
Input connections are made via the 3-pin XLR (pin 2+) or 6.3 mm plug combination connectors on the rear panel
of the amplifier. The inputs are actively balanced. The input overload point is high enough to accept the maximum
output level of virtually any signal source.
CONNECTING OUTPUTS
13
All models have one combination 4 pole twist lock output connector per channel. Channel A output allows for CH A
1+ Pos / 1- Neg and channel B 2+ Pos / 2- Neg to use a single 4 conductor speaker cable.
13
13
26
11 12
11
12