Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Plantilla vitrocerámica
E-VII. Cleaning and maintenance
o Always allow the appliance to cool down before cleaning to avoid a
burn injury.
o Do not use caustic or abrasive agents, coarse wire wool or hard tools
as these can damage the surface finish.
o Normally, wiping with a soft cloth dampened with hot detergent and
drying with a soft cloth is sufficient but for stubborn marks the
following is recommended:
o Vitreous Enamel or Stainless-Steel parts use only a cleaner that is
recommended for these types of material – avoid chloride-based
products (such as bleach).
o Glass Ceramic surface, if any spillage becomes burnt on, remove
with a ceramic glass cleaner or scraper and clean with a cleaner-
conditioner containing silicone.
o Do not allow the ceramic glass surface to become scratched or
damaged as this could lead to a hazard.
E-VIII. Installation
The installation must be carried out by a suitably
qualified person, in accordance with the current version
of the following. Before connecting the appliance, make
sure that the supply voltage marked on the Rating Plate
corresponds with your mains supply voltage.
WARNING: THIS APPLIANCE MUST BE EARTHED.
o This appliance should be wired into a 32 A double pole switched fused
spur outlet, having 3 mm contact separation and placed in an easily
accessible position adjacent to the appliance. The spur outlet must still
be accessible to enable the appliance to be disconnected from the
mains supply.
o Care must be taken to avoid the cable being in contact with hot parts
of the appliance.
o The appliance must not be connected to the mains supply by means of
a 13A plug and socket.
www.derkochline.com
Ceramic Hob
19
Tabla de contenido
