User Maintenance Instructions - Powermate Px P010-0037SP Manual De Instrucciones

b. Fluid control knob (see Figure 2) - turn in a clockwise direction to
reduce the amount of paint and counterclockwise to increase the
amount of paint. This knob controls the amount of paint that is mixed
with the air. NOTE: If the fluid control knob is turned in all the way,
the gun will emit only air.
c. Spray pattern shape (see Figure 4) - loosen the air cap nut and turn
the air cap for the desired spray pattern. Hand tighten the air cap nut
after adjustment.
Round pattern used to draw fine lines with the gun close to the work
surface, for touch up work and for painting surfaces in difficult to reach
areas. To achieve this pattern, turn
the air cap at a 45 degree angle.
Full fan pattern used with the spray gun 6-9" from the work surface. To achieve this pattern, turn the air cap
either horizontally or vertically.
d. Adjust the regulator to the desired setting by turning the regulator knob counterclockwise to increase pressure
and clockwise to decrease pressure.
Do not adjust the fluid control knob or the pattern control knob out past the first visible
thread while the paint gun is under pressure or they could fly out and cause serious injury.
IMPORTANT: Keep the spray gun clean. To avoid clogging the air and paint passages and possibly ruining the
spray gun, clean the spray gun immediately after each use. NOTE: Paint and other material dry quickly in the small
passages rendering the gun useless due to the difficulty of removing hardened paint from the passages inside the
gun. If the passages become clogged and the spray gun stops working, follow the instructions in "TO CLEAN PAS-
SAGES" below.
After Each Use
Shut off the air supply to the paint gun and release the pressure in the paint gun by
pulling the trigger before cleaning to avoid injury.
1. Drain and clean the cup. To clean the gun passages, put a small amount of thinner or approved solvent in
the cup. Attach the cup to the gun and spray the liquid through the gun while shaking the gun vigorously.
Periodically pull and release the trigger to help break loose dried-on material.
2. Wipe the gun and cup exterior with a solvent soaked rag.
To avoid of the risk of fire and/or explosion, place cleaning rags and other flammable
waste materials in a secured metal container. The container should be disposed of properly in accordance
with local, state and federal regulations.
3. When cleaning out water based paints or materials with water, spray mineral spirits through the gun
afterwards to prevent corrosion.
When blowing out the hose, the open end should be aimed away from any person to
avoid blowing solvent into the eyes of skin causing possible injury.
To Clean Clogged Passages
1. Disassemble the spray gun and soak all metal parts in thinner or appropriate solvent for 15-30 minutes. A
longer soaking time may be required for severely clogged passages. Clean the parts with a soft wire brush.
NOTICE: Do not use lye or other alkalis solutions to clean the spray gun. These solutions attack
aluminum alloys and will ruin the spray gun over time.
NOTICE: Never use metal objects to clean precisely drilled passages. Damaged passages will cause
improper spraying.
2. Apply light machine oil to to the leather packing. This will help prevent air leakage. If air leakage continues
after application of oil, the packing is probably worn out and should be replaced. The gun's packing and
o-rings will be damaged by leaving the spray gun assembly immersed in solvent over extended periods.
OPERATING INSTRUCTIONS (continued)

USER MAINTENANCE INSTRUCTIONS

5 - ENG
Figure 4