HSM Pure 730 Instrucciones De Servicio página 14

english
6 Troubleshooting
Note
The safety element is fi tted with contact protection. The document shredder switches off if you press
the safety element during the shredding process.
Display Problem
Paper jam You have fed in too much paper.
Continu-
ous lamp
Overload
Flashing General
light fault dis-
plays
Shredded
material
container
full
Door
open
Safety
element
pressed
14
Measure
 If more than 1/2 an A4 sheet has already been processed, the shredder
will draw in the paper stack even though more sheets than permitted
have been fed in.
 If the number of sheets to be shredded is far in excess of the number of
sheets processable, the cutting unit runs in reverse for a few seconds
and pushes the paper back out.
• If necessary, press the reverse button "R" to remove the stack of paper.
• Take half the stack of paper.
• Feed the paper in portions.
• The motor was overloaded. Let the shredder cool down for approx.
15 – 20 mins. before using it again.
• A fault has occurred while shedding paper.
Pull the paper out of the slot to clear the light barrier.
• Empty the shredded material container.
Note
If you press the reverse button briefl y before removing the container,
part of the material is pulled back into the cutting apparatus and does
not fall inside the document shredder.
• Close the front door.
• Do not press the safety element.
HSM Pure 730
01/2017