Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5.
Use the provided loop-through terminals (see graphic below). When this wiring method is used, you
should be aware that when a speaker is not plugged in there is no path to subsequent speakers (see
graphics below). An alternative is to wire incoming and outgoing cables in parallel. Pin 2 is + and Pin 3
is -.
Power Amplifier
+
6.
Insert the pre-wired Euroblock connector, ensuring the correct polarity is being used.
7.
Begin to insert speaker into the "C" shaped speaker mounting bracket. Make sure to connect the
snap hook to the safety hook on the back of the speaker. When the speaker is flush with the ceiling
leaving only the black magnetic brim exposed, begin to tighten the 4 attachment screws which are
connected to the mounting tabs (see graphics below). The screws will automatically turn once you
begin rotating the screw clockwise. Repeat for all 4 tabs and make sure not to overtighten the screws.
Note: Before you put the speaker into the ceiling, make sure all attachment screws are turned
completely counter-clockwise so that the mounting tabs are touching the side of the steel backcan.
Note: Make sure to position the speaker so that the mounting tabs do not sit above the opening in the
"C" shaped speaker mounting bracket.
8.
Use a flat-head screwdriver to rotate the Tap Selector so that the correct power setting is adjacent to
the arrow. Note that there are separate 70V and 100V scales, depending on the line voltage being
used (see the graphic below). The transformer may also be bypassed by selecting the 16 ohm
position. It may be best to leave the grill off until setting the power is complete in case adjustments
are needed.
9.
Attach the magnetic grill on the speaker.
Speaker 1
-
Speaker 2
Speaker 3
To Subsequent
Speaker
5
Tabla de contenido
