STEP 3:
Attach the tongue assembly (1) to the tank assembly (3) using two 3/8 NC x 4 hex bolts (12), four 3/8 flat washers (13)
and two 3/8 NC nylock nuts (14). Tighten hardware.
STEP 4:
Stand the beam assembly (4) up on end. Two people may be needed for this step to ensure safety. Make sure that the
beam is stable and on a level surface. Roll the tongue and tank assembly into position between the two tabs on the
beam. Install 5/8 NC hex flange screw (15) and 5/8 NC flange lock nut (16). Tighten nut to remove excess play but still
allow beam to pivot.
ITEM
1
Tongue Assembly
3
Tank Assembly
12
3/8 NC x 4 Hex Bolt, GR5
13
3/8 Flat Washer
14
3/8 NC Nylock Nut
ITEM
4
Beam Assembly
15
5/8 NC x 4-1/4 Hex Flange Screw, GR5
16
5/8 NC Flange Lock Nut
Page 11
DESCRIPTION
DESCRIPTION
QTY
1
1
2
4
2
QTY
1
1
1