Quick SBC 1100 ADV PLUS FR Manual Del Usuario página 20

INSTALLATION
GB
EQUIPMENT SUPPLY
The equipment already includes a power cable for AC supply. For connections to an AC supply see fig. 2A.
Before powering up the battery charger check that the power supply voltage, described on the rating la-
bel, corresponds to that supplied by the AC supply source.
A 2 pole switch must be installed in the electrical circuit for the sole use of switching the equipment
ON & OFF. The insulation between the contact points of the connections of the AC supply must be at
least 3 mm.
The connections to the AC supply must be carried out according to local electrical codes.
WARNING: before connecting or disconnecting the cables from the electrical terminals of the bat-
tery charger, make sure that the equipment is disconnected from the AC mains and the batteries.
WARNING: in cases where the power supply cable could be damaged, have this changed by a
"QUICK ® " service centre. In order to avoid accidents, the equipment must only be opened by au-
thorised personnel.
FIG.2A
5 cm
5 cm
5 cm
20
SLAVE B SLAVE A MASTER
5 cm
Battery switches
battery
n° 3
battery battery
n° 2 n° 1
Neutral
Blue
Yellow Earth
Green
Live
Brown