Aquaglide VELOCITY 10.0 El Manual Del Propietario página 7

1. Locate a flat, dry area with access to outlet for electrical pump. The best setup position
will also make launching easy. Never drag product as damage may occur.
2. Unfold product completely and locate Main Valve [1]. To help future storage, closely note
original folding & packaging method. Remove valve cap and confirm valve is in inflate (1-way
airflow) position (see HR Valve Operation Graphic).
3. Insert air pump hose with proper valve fitting into Main Valve [1], lock into place. Use
pump to inflate Main Valve [1] to Working Pressure as shown in Chart 1. Check for proper
pressure using gauge (manometer). Replace valve cap.
4. Repeat step 3 instructions (if necessary) to inflate each chamber to proper Working
Pressure shown in Chart 1 until all chambers are properly inflated.
5. If this item will be attached to others, follow steps below to prepare connections prior
to launching. When connecting multiple items together follow guidelines carefully. Use only
Two-Step Vario-lock cinch straps and Aquaglide connecting rings.
a. Straps should first be attached to 'Connector' items (example: Swimstep,
Splashmat, Speedway, Breezeway or Deck) only where a connection is needed. Your
configuration determines how many straps are needed; you may use all, some, or none of
the straps supplied with connectors.
b. 'Connector' items generally go between or attach to feature items. Connectors
should not be attached to other connectors.
c. Use all available rings to make connection. Standard connections use 5 rings.
Some items use 3 or occasionally 7 rings/ straps. Velocity Slide 10.0 is a feature item with a
5-ring sets on 3 sides.
d. After launch and anchoring instructions (below), float 'Connector' with
necessary straps attached into desired position. Note: a matching set of connecting rings is
required on feature item.
e. Attach center strap to center ring on feature item. Connect loosely, then work
outward until all straps are connected.
f. Dive beneath to tighten all straps securely. Dive mask and several attempts may
be required. Make sure connection is tight and there is NO GAP between items. Failure to
connect items properly may result in injury or death. See E.
E
6. To launch product, lift completely and place in water. Large items may require many extra
people to accomplish this. Never drag product as damage may occur. Confirm that suitable
anchor(s) and mooring lines are in place before launching this item.
7
3
1
2
0mm
5X
www.aquaglide.com