Safety Instructions; Operating Procedure/Installing/Adjustment - Carson Reflex Wheel LCD 2,4 Manual De Instrucciones

Safety Instructions

R/C models can be dangerous and could cause
personal injury or damaged to property. Thus, for
your safety and that of others,
1. Follow all the cautions, warnings, and
instructions in this manual.
GB
2. Be „Safety Conscious" and use common sense at
all times.
3. Remember that operating any R/C model
demands skills developed through proper
instruction and training - they are not acquired
immediately.
4. Don't run risks, such as operating your model in
adverse weather.
5. The remote control's special technology
makes the 2.4 GHz transmitter and receiver
a single unit and coordinates them together.
Therefore, the receiver is not influenced by any
other transmitter or radio signal. It is no longer
necessary to check whether other models nearby
are running on the same frequency channel, as
was the case with previous frequencies (27/35/40
MHz).
6. Respect the rules of the track on which you
operate your model.
7. Running your model in the street is very dan-
gerous to both automobile drivers and your
model. Avoid running your model in the street.
Caution
Control of models is impossible with insufficient or
no voltage in the transmitter or receiver. A receiver
any battery that is too weak will move the servo(s)
very slowly, and that may cause erratic operation
of your model. When using a car that operates
Operating Procedure
Many publications say that the setup sequence
for the transmitter and receiver don't play a role
anymore with 2.4 GHz sets. However, we recom-
mend sticking to the sequence typical for previous
sets.
• Before operation: First turn on the transmitter,
then the receiver. Lastly, connect the drive bat-
tery to the control unit.
18 CARSON Reflex Wheel LCD 2.4 GHz 50 050 0031
8. Never aim or direct your model car at any person
or animal. These model cars accelerate very
quickly and can cause serious physical injury.
9. You are responsible for animal safety when
operating your model. Keep your model away
from any visible wildlife. On water, watch care-
fully out for fishing lines as these may entangle
the boat's propeller or in other ways disrupt the
operation of the boat.
10. At any time during the operation of your model,
should you sense, feel, or observe any erratic
operation or abnormality, end your operation. Do
not operate it again until you are certain that the
problems have been fixed.
11. Take advantage of the failsafe setting. During
a breakdown in signal transmission (such was
when transmission voltage is too weak), this
setting shifts the model into a control mode that
prevents it from taking off uncontrolled.
Take your time to read all the way
through the pages of this booklet
before starting the installation
of this Digital Proportional Radio
Control System.
both the electric motor and receiver on bat the
same battery, such as a BEC system, you should
discontinue operating the car when the top speed
becomes sharply reduced, otherwise loss of control
will result soon afterwards.
• After operation: Disconnect the battery from the
control unit. Turn the receiver off, and then the
transmitter.
• Before and after operating the transmitter, make
sure that trim is in the desired place and that all
checks have been made.