Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Specifications:
Size:
7965: 6.0" dia. x 4.8" high
7970: 6.0" dia. x 5.8" high
Weight:
approx. 2 lbs.
Input Voltage:
12-24 VDC system
Input Current:
High intensity mode:
2.8 amps @ 12.8 VDC
Maximum power consumption: 36 Watts
Temp. Range:
-30°C to +50°C
Installation & Mounting:
Important! This unit is a safety device, and it must be
connected to its own seperate, fused power point to as-
sure its continued operation should any other electrical
accessory fail.
Carefully remove the beacon and place it on a flat surface. Examine
the unit for transit damage, and locate all parts. If damage is found,
or parts are missing, contact the transit company or ECCO. Do not
use damaged or broken parts.
!
Caution: When drilling into any vehicle surface,
make sure that the area is free from any electrical wires,
fuel lines, vehicle upholstery, etc. that could be damaged.
Permanent Mounting:
Select the desired location on a flat surface for the strobe beacon
to be mounted. The visibility of the flash and ease of wiring access
should be taken into consideration in the selection of the mounting
location.
1.
Using the base gasket as a template, mark the three mount-
ing hole locations (see Figure 1).
2.
Drill the holes using a 7/32" drill size.
3.
A fourth hole may be drilled for wire access as shown in Fig-
ure 1, or the wires may be routed through the slot in the base
for external access.
4.
Connect the power wires as shown in the wiring section (see
Figure 3).
5.
Mount the strobe with #10 hardware.
920-7900-00 Rev. D
Figure 1
Pipe Mounting:
The 7965/7970 series base comes with 1" NPT threads for pipe
mounting.
Temporary Mounting, Vacuum-Magnet Mount:
The 7965/7970 series beacons are available as vacuum-magnet
mount (7965X-VM & 7970X-VM) units. The Vacuum-Magnet Mount
feature includes a suction cup on the bottom of the beacon, with a
magnet inside of the suction cup, for a secure, temporary mount. The
beacon should be placed in the center of the roof where the least
amount of curvature occurs. Before installing, make sure there is
no debris on the bottom of the beacon or on the roof of the vehicle,
which could reduce the holding power of the suction cup and mag-
net. Place and remove the beacon without sliding to avoid scratching
the paint on the vehicle. After placement, the beacon should adhere
firmly to the surface. If the unit slides or moves easily, a proper in-
stallation has not been obtained. To release the vacuum, lift the tab
to release the airlock (see Figure 2). To protect the Vacuum-Magnet
Mount assembly, return beacon to the box when not in use. Do not
attempt to attach the beacon to an ice-covered surface.
WARNING!
!
Maximum recommended vehicle speed for safe operation
using the Vacuum Mount model is 65 mph (104 km/h), when fitted
to the center of a vehicle roof of steel construction. Higher speeds
could cause the mount to fail, resulting in the beacon flying off
of the vehicle, which could cause damage to other vehicles, and
injury or death to the passengers. The vacuum-magnet mount is
not intended as a permanent mounting for the beacon The vacuum-
magnet mount unit must be mounted on a flat smooth magnetic
surface (i.e. no fiberglass, ribbed style roofs, etc.). Ensure that the
magnet is kept clean.
Figure 2
Page 2 of 4
Tabla de contenido
