Safety Notes - Stage Line LED-10SPOT Manual De Instrucciones

GB 1 Applications
This compact spotlight with high power RGBW
LED is used for effect illumination on small
stages, in clubs, party rooms etc. Various oper-
ating modes are available (e. g. automatic show
programs, music control).
The spotlight is designed for control via a
DMX light controller with DMX512 protocol (4 or
7 DMX channels), but it can also be operated
without a controller; either as an individual unit
or in combination with several LED-10SPOT
spotlights in master/slave mode.

2 Safety Notes

The units (spotlight and plug-in power supply
unit) correspond to all relevant directives of the
EU and are therefore marked with
WARNING The power supply unit uses dan-
Please observe the following items in any case:
G
The units are suitable for indoor use only.
Protect them against dripping water and
splash water, high air humidity and heat (ad-
missible
0 – 40 °C).
G
Do not operate the spotlight or immediately
disconnect the power supply unit from the
socket
1. if the spotlight or the power supply unit is
visibly damaged,
2. if a defect might have occurred after a unit
was dropped or suffered a similar acci-
dent,
3. if malfunctions occur.
In any case the units must be repaired by
skilled personnel.
G
No guarantee claims for the unit and no liabil-
ity for any resulting personal damage or
material damage will be accepted if the unit
(spotlight or power supply unit) is used for
other purposes than originally intended, if it is
not safely installed or not correctly con-
nected/operated, or if it is not repaired in an
expert way.
If the units are to be put out of opera-
tion definitively, take them to a local
recycling plant for a disposal which is
not harmful to the environment.
8
gerous mains voltage. Leave
servicing to skilled personnel;
inexpert handling may result in
electric shock.
ambient temperature
3 Installation
To prevent heat accumulation inside the unit,
always position it in such a way to ensure suf-
ficient air circulation during operation. Never
cover the air vents of the housing.
Fasten the spotlight via its mounting bracket,
e. g. with a stable mounting screw on a cross-
bar. Release the two locking screws on the
bracket, adjust the spotlight as desired, and
then fasten the screws.
WARNING Install the spotlight safely and
.
4 Operation
WARNING
range:
Please note that fast changes in lighting may
trigger epileptic seizures with photosensitive
persons or persons with epilepsy!
Connect the low-voltage plug of the power sup-
ply unit provided to the low-voltage jack on the
side of the spotlight. Connect the power supply
unit to a mains socket (230 V~ / 50 Hz). Thus, the
spotlight is switched on, its fan starts running
and the last setting is displayed for approx.
17 seconds.
To switch off the spotlight, disconnect the
power supply unit from the mains.
The settings of the spotlight are made via a
system menu. This menu is operated via four
buttons by means of the display (menu struc-
ture
press any button. The last setting will be dis-
played. If no button is pressed, the display will
be extinguished after approx. 17 seconds. Set
the corresponding operating mode according to
chapter 5 or 6.
Note: If you disconnect the spotlight from the
power supply before the display is extinguished,
any setting made will not be memorized.
expertly. When installing it at a
place where people may walk or
sit under it, additionally secure it
(e. g. via a safety rope on the
mounting bracket; fasten the
safety rope in such a way that
the maximum falling distance of
the unit will not exceed 20 cm).
To prevent damage to your eyes,
never look directly into the light
source.
page 11, fig. 1). To activate the display,