Note - Rockford Fosgate PUNCH PBR300X4 Instalación Y Funcionamiento

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

Power
Connection
7.
Securely mount the amplifier to the vehicle or amp rack. Be careful not to mount the amplifier on
cardboard or plastic panels. Doing so may enable the screws to pull out from the panel due to road
vibration or sudden vehicle stops.
8.
Connect from source signal by plugging the RCA cables into the RCA/Speaker Harness input jacks,
then insert the four pin Molex connector into the mating four pin INPUT connector at the amplifier.
From
Source Unit

NOTE:

When the installation requires a High Level(Speaker) input, the RCA/Speaker
Harness will need to be cut on the speaker wire side of the y-splitter. Then
connect the harness(s) to the corresponding vehicle wires.
CAUTION: Always ensure power is off or disconnected at the amplifier before
connecting RCA cables. Failure to do so may cause injury, damage to the
amplifier and/or connected components.
9.
Connect the speakers. Strip the speaker wires 1/2" and connect to the Speaker Wire Harness, then
insert the four pin Molex connector into the mating four pin SPEAKER connector at the amplifier. Be
sure to maintain proper speaker polarity. DO NOT chassis ground any of the speaker leads as
unstable operation may result.
NOTE:
4 ohm Stereo ONLY.
10. Perform a final check of the completed system wiring to ensure that all connections are accurate.
Check all power and ground connections for frayed wires and loose connections which could cause
problems. Install inline fuse near battery connection.
NOTE:
Follow the diagrams for proper signal polarity.
I
NSTALLATION
7
Tabla de contenido
loading

Tabla de contenido