mundoclima MUCOR-48-H9T Manual De Instalación Y Usuario página 57

Avoid button:
2
1. In any mode of boot, press the button to turn on the function.
2. Press " " , "
3
Power button: Operation starts when this button is pressed and stops when you press the
button again.
Fan button: This button is used to select the desired fan speed. Each time you push the
4
button, the fan speed is shifted in the following sequence:
LOW MED
Fan speed display:
1 2 4
Select LOW fan speed and zones 1~2 will illuminate.
Select MED fan speed and zones 1~4 will illuminate.
Select HIGH fan speed and zones 1~6 will illuminate.
Select AUTO fan speed and zones 1~7 and "AU" will illuminate .
Note: When using the remote control to choose strong wind, wind speed 1~7 will illuminate.
Swing button:
5
1. This button is used to set the horizontal and vertical air ow.
2. Each time the air ow direction button is pressed, the settings change as follows: Set
vertical air ow→ Cancel vertical air ow→ Set horizontal air ow→ Cancel horizontal air ow
→ Set simultaneous vertical and horizontal air ow→ Cancel simultaneous vertical and
horizontal air ow→ Set horizontal air ow.
WARNING: Manually moving the horizontal and vertical air ow direction louvers could damage
the air conditioner.
6 button:
1. Under the Test Running mode, press "
2. In other states,press the "
To cut to 17 °C again when press downward adjustments set temperature no longer change;
To rise to press adjusted upward again when 30 °C set temperature no longer change.
When setting the temperature, the key cannot adjust the temperature quickly, it can only be
achieved by pressing up and down.
", " " close this function.
HIGH AUTO
6 7
" "
"and" " to adjust the temperature within a range of 17°C~30°C，
" to be able to check view indoor, outdoor, fault code .
57