HoMedics AR-45 Manual De Instrucciones E Información De Garantía página 5

1. On/Off and Speed Settings
• To turn the air cleaner on, press the ON/OFF
When the air cleaner is on, the ON/OFF button on the control panel will be lit and
the air cleaner will start to operate on LOW speed.
• Once the air cleaner is ON, press the SPEED+ button to increase the fan speed
to the MED setting. Press again to increase the fan speed to HIGH setting. To
decrease the fan speed, press the SPEED– button until your desired setting is
reached. The fan speed setting is indicated by the illuminated ring around the fan
symbol.
• To turn the air cleaner OFF, simply press the ON/OFF
2. Timer
There are four possible timer settings: 2 (two) hours, 4 (four) hours, 8 (eight)
hours, and 12 (twelve) hours. To activate the timer press the TIMER+ button
on the control panel. Each time the + button is pressed, it will display the
successive settings. To return to a setting already passed, press the TIMER–
button. Once a timer setting has been selected, it will remain displayed on the
TIMER screen. To operate continuously, cycle down through all timer settings
until no timer setting is displayed.
3. Oscillation
To activate the oscillation feature, press the
the button a second time. Unit will not automatically realign with foot when
oscillation is stopped. To achieve alignment, stop oscillation at the moment the
body becomes aligned with the foot.
4. UV-C Bulb
The UV-C technology in this air cleaner kills germs, bacteria and viruses. To
activate the UV-C bulb, press the UV-C button on the control panel. To turn the
UV-C bulb off, press the button again.
5. Clean Filter Indicator
The air cleaner is equipped with a CLEAN FILTER indicator to let you know when
it is time to clean the HEPA filters, about every 480 hours of use. When the HEPA
filters are ready to be cleaned, the CLEAN FILTER indicator will light up on the
control panel.
If the air cleaner is used daily, we recommend cleaning the HEPA filters more
frequently.
Once the HEPA filters have been cleaned, press and hold the CLEAN FILTER
button until it beeps to reset the Indicator.
button on the control panel.
button on the control panel.
button. To stop oscillation, press
8
6. Using the Remote Control
Battery Installation
One CR2025 3V battery is included with the remote control. To activate the remote
control, pull out the plastic tab protruding from the remote control housing. To
change the battery, remove the battery door on the bottom of the remote by sliding
the tab and pulling the door away from the back of the remote. Insert the battery
into the remote with the + symbol facing up as shown on the drawer.
NOTE: Always keep the battery and remote control out of the reach of children
and pets.
BATTERY NOTE
• If the unit is not going to be used for a long period of time, remove batteries
to prevent damage due to possible battery leakage.
• Clean the battery contacts and also those of the device prior to battery
installation.
• Remove used batteries promptly.
• Dispose of batteries properly in accordance with all local, state and federal
regulations.
• Do not dispose of batteries in fire. Batteries may explode or leak.
• Use only CR2025 battery.
• Incorrect battery installation may cause damage to remote.
Power ON/OFF
Bottom of Remote
Timer Settings
Speed Settings
Oscillation ON/OFF
UV Bulb ON/OFF
Power
Timer
Fan Speed
Oscillation
UV
UV Light
9