Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4 Operating
GB
4.4
Starting
application
44
Make sure that the skin areas to be treated are shaved, dry, clean and
free of creams, deodorants etc. Proceed as follows:
1.
Plug the end of the device plug of the power supply cable into the de-
vice
and the power supply plug into a socket. The readiness indica-
2
tor
flashes green.
9
2.
Press the ON/OFF button
1, (blinking) and the device fan switches itself on. The device is now
ready for positioning on the skin.
3.
There are two ways for choosing the intensity:
a.
Set the intensity that you have tested and which is suitable for your
skin, by pressing the ON/OFF button
long, until the desired intensity (Level 1 to 4) is lit on the intensity dis-
play
.
7
b.
or: Place the light area
in skin tone sensor, the device can automatically choose the safest in-
tensity level. The readiness indicator
and the (automatically chosen) level is shown in the intensity display
. If intensity display
7("energy")
area is to dark. Choose another area, if possible.
4.
The light area
be emitted by the device. Press the trigger button
pulse. When the pulse is emitted, you will see a bright flash and may
hear a clicking sound.
5.
Now place the device on another area of the skin while it charges for
the next light pulse.
6.
Then emit a new light pulse on the other skin area.
7.
Repeat this procedure for other planned skin areas.
8.
Switch the device off by pressing and holding the ON/OFF button
. Readiness indicator
1
immediately.
. The intensity display
1
on the skin diretly. By taking use of the build-
5
7
must lie fully on the skin, so that a light pulse can
5
will flash green and cooling fan will stop
9
briefly in succession so
1
illuminates green permanently
9
is still blinking, skin tone of treated
to trigger a light
8
shows level
7
Tabla de contenido
