Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Connecting to a DVD Player
via HDMI
Please refer to your DVD player's instruction book
for additional information. Power off both the TV and
the device before making any connections.
Note: Not all cables shown in the illustration are
supplied.
•
If your DVD player has an
connect via HDMI for better video and audio quality.
•
When you connect to DVD player as illustrated above,
switch to the connected HDMI source. See, Input
Selection section for more information on changing
sources.
Connecting to a DVD Player
If you want to connect a DVD player to your TV, you
can use the connectors of the TV set. DVD players
may have different connectors. Please refer to your
DVD player's instruction book for additional information.
Power off both the TV and the device before making
any connections.
Note: Cables shown in the illustration are not
supplied.
•
If your DVD player has an
connect via HDMI. When you connect to a DVD player
as illustrated below, switch to the HDMI source. See
"Input Selection" section.
•
Some DVD players are connected through
COMPONENT SOCKETS (YPbPr). YPbPr can be
used only when you connect a device that has a
YPbPr output through the PC input with YPbPr to
PC cable (YPbPr cable is not supplied).
•
You may also connect through the SCART sockets.
Use a SCART cable as shown below.
HDMI socket, you can
Note: These three methods of connection perform the
same function but in different levels of quality. It is not
necessary to connect by all three methods.
HDMI Cable
(not supplied)
Inserting Batteries
•
External device
•
Note: Remove the battery from remote control
handset when it is not to be used for a long period.
HDMI socket, you can
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.
To Switch the TV On
•
•
•
•
English - 54 -
Remote Control Handset
Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
Insert two
AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Switching On/Off
Connect the power cord to the 220-240V AC, 50 Hz.
Then the standby LED lights up (The led will blink
during the standby On/Off).
To switch on the TV from standby mode either:
Press the "
" button,
P+ or P-
on the remote control.
Press the "
" button, -P/CH or P/CH+ button on
the TV. The TV will then switch on.
or a numeric button
Capítulos
Tabla de contenido
