Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983
PowerBOSS™
ASSEMBLY
Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-743-4115.
Remove Generator From Carton
1.
Set the carton on a rigid flat surface.
2.
Remove everything from carton except generator.
3.
Open carton completely by cutting each corner from
top to bottom.
4.
Leave generator on carton to install wheel kit.
Carton Contents
Check all contents. If any parts are missing or damaged, call
the generator helpline at 1–800–743–4115.
• The generator
Figure 1 — Install Wheel Kit
Nylon Washer
45 mm Cap Screw
Handle
Use existing hardware
to attach left side of
support leg to unit
6200W Portable Generator
Handle Pin
Nylon Washer
Flat Washer
Nut
Nut
Vibration Mount
3/4" Cap Screw
www.mymowerparts.com
• Generator and engine owner's manuals
• Engine oil
• Wheel kit
Install Wheel Kit
NOTE: Wheel kit is not intended for over-the-road use.
You will need the following tools to install these
components:
• 1/2" or 13mm wrench
• 7/16" wrench
• Socket wrench
• 1/2" or 13mm socket
• 7/16" socket
• Pliers
Refer to Figure 1 and install the wheel kit as follows:
1.
Tip generator so that engine end is up.
2.
Slide axle through both mounting brackets.
3.
Place a wheel on each side with air valve facing out.
Axle
20 mm Cap Screw
E-Ring
Support Leg
Nut
6
ASSEMBLY
Wheel
Flat Washer
Capítulos
Tabla de contenido
