Warranty Statement - Worx WG202 Manual Del Usuario

before entering the material to be cut.
Always work going away from people and
solid objects such as walls, large stones, trees,
vehicles etc.
If the blade stalls, immediately stop the Hedge
trimmer. Disconnect the hedge trimmer from
the power supply and clear the jammed debris
from the cutting blades.
Wear gloves when trimming thorny or prickly
growth.
Move the hedge trimmer to feed the branches
directly into the blade cutting edges.
Do not try to cut stems that are too large to feed into the cutting blade.
Allow the cutting blades to reach full speed
before cutting. When operating, keep the
cutting blades away from people and objects
such as walls, large stones, trees, vehicles, etc.
If the blade stalls, immediately stop the
trimmer. Disconnect from the power supply
before attempting to clear jammed debris from
the cutting blades.
TOP CUTTING
Use a wide sweeping motion (See Fig I). A
slight downward tilt of the cutting blades in
the direction of motion gives the best cutting
results.
10
SIDE CUTTING
When trimming the sides of the hedge, begin
at the bottom and cut upwards (See Fig J),
tapering the hedge inward at the top. This
shape will expose more of the hedge, resulting
in a more uniformed growth.
Warning: Check the extension cord
before using. If damaged, replace
immediately. Never use your tool with
a damaged cord, as this could cause
electrical shock and result in serious
injury.
If the supply cord is damaged, it should be
replaced by an approved service center.
Do not expose tool to rain.
MAINTENANCE
CLEANING
Disconnect from power supply. Using a soft
brush to remove debris from all air intakes and
Hedge Trimmer
CTC-WG202 WG203-M-060609.indd 10
All manuals and user guides at all-guides.com
cutting blade.
Wipe the surface with a dry cloth.
Warning:
Never use water for cleaning your
trimmer. Do not clean with chemicals, including
gasoline, or solvents as this can damage your
trimmer.
LUBRICATING THE CUTTING BLADE
For easier operation and longer life, lubricate
the cutting blades before and after each use.
Before lubricating, make sure your trimmer is disconnected from the power supply. Apply oil
between the two blades (See Fig K).
Your trimmer should be stopped, disconnected
and oiled occasionally during use.
AT THE END OF THE CUTTING SEASON
Clean your trimmer thoroughly.
Check that all nuts and bolts are secure.
Visually inspect the trimmer for any worn or
damaged parts.
TO STORE YOUR HEDGE TRIMMER
The trimmer blade cover holder is provided
with 2 hanging slots for storing the trimmer
on the wall. (See Fig L) Ensure the blade cover
holder is fitted before storage. Store in a dry
place where your trimmer can be protected
from damage.

WARRANTY STATEMENT

30 DAY Satisfaction Guarantee
If for any reason you are dissatisfied with any
WORX product, you can return the product,
along with proof of purchase, within 30 days
for a full refund.
If your WORX product becomes defective due
to faulty materials or workmanship within the
specified warranty period of;
• 24 months for DIY and light trade use, from
the date of purchase.
We guarantee to repair or replace all defective
parts free of charge, repair products subject
ENG
2006-6-9 17:03:46