Euphonix Artist Serie Manual Del Usuario página 5

professional control surface
6. Plug the other end of the Ethernet crossover cable into an open Ethernet jack on your
computer, router, or Ethernet switch (Figure 1-5).
An Ethernet router or switch is required to connect additional MC Mix units or to a local
area network. Note that connecting directly to the computer (Figure 1-5-right) may require
removing your Internet cable.
Figure 1-5 MC Mix connected to router (left) and directly to computer (right)
7. Turn on your router (if applicable), then turn on your Mac and wait until it finishes starting up.
8. Press and release the POWER switch on your MC Mix.
Look at the top-right of your screen and wait up to 60 seconds. A green icon
menu bar indicates correct installation.
If you did not see the green icon: If your Mac is pre-2002 and you are using an Ethernet
router or switch, you need to purchase a normal straight-through Ethernet cable (instead
of the crossover Ethernet cable supplied) from a computer store.
9. Launch your application and open a project (Logic, Cubase, Digital Performer, Pro Tools, etc.).
10. To setup your application to work with the MC Mix, refer to the EuCon Application Setup
Guide that you downloaded at the beginning of this section.
Logic users do not need this document because additional setup is not required.
All manuals and user guides at all-guides.com
Artist Series
in the
5