Safety Instructions - ProMed UVL-54 All-In Manual Del Usuario

Special quality features
• All-In function: With the Promed UVL-54 All-In, all standard UV / LED gels, coatings and
acrylics can be cured.
• Pre-programmed operating times: Depending on the application, the user can select the
time required (10 / 30 / 60 / 99 sec).
• Infra-red sensor: Once the customer inserts their hand into the device, the Promed UVL-
54 All-In registers this using 2 sensors and the device starts automatically.
• Painless mode: With this function, the output of the Promed UVL-54 All-In can be
increased in stages and therefore slow down the polymerisation of the gel for sensitive
customers (e.g. for the burning feeling on the nail bed when the gels are cured).
• Low power mode: To switch the Promed UVL-54 All-In between 48 W and 54 W output.

Safety instructions

Please pay attention to the following information before first time operation: Never place the
lamp in direct contact with fire, gas, oxygen or hot objects such as hot plates.
Please observe the following during operation:
1. Power supply of the unit: 220 - 240 VAC.
2. Take every precaution possible to ensure that the lamp does not fall down or get
damaged in any other way.
3. If problems do arise with the lamp, take it immediately in to get it repaired.
4. Do not lubricate or wash the lamp.
5. Only for home use.
6. Scrupulous supervision is required when the device is being used in the vicinity of
children.
DANGER!
• Do not place the unit in direct contact with water or other fluids.
• Never place or use the unit in a wet or moist environment.
• Do not touch the unit with wet hands.
• Only operate the unit with the specified line voltage.